Rocky-mountain-radar RMR-D210 Uživatelský manuál stáhnout pdf (Strana 2)

5. Care and Maintenance

Your Rocky Mountain radar detector is an example of

superior design and craftsmanship.

The following suggestions will help you care for your detector

so you can enjoy it for years.

·Never leave your detector on the windshield or dashboard

when your vehicle is left parked. The temperature in the

vehicle durning the summer can reach levels above what is

considered to be safe for this detector.

·To make you less susceptible to break-in and theft, remove

the detector from your windshield or dashboard when leaving

your vehicle.

·Do not expose the detector to moisture, rain, dew, road

splash, or other liquids that can damage the internal

components and reduce the sensitivity of the detector.

6. Troubleshooting

If the detector does not turn on:

·Check the power cord. Be sure all power connectors are properly

installed.

·Check the fuse that controls the power to the cigarette lighter

socket.(See your vehicle’s owner’s manual for reference.)

·The cigarette lighter socket might be dirty. Clean it with a fine

emery cloth to ensure a good, clean connection.

·There might be a problem with the vehicle’s electricity.

·Make sure that the volume control is in the ON position.

Caution : Do not place any metal objects other than the cigarette

lighter or a cigarette lighter plug in the cigarette lighter

socket. Doing so could blows a fuse in your vehicle or

cause the metal object to become very hot.

If the detector gives a false alert when the vehicle hits bumps:

·Check the vehicle’s electrical system, including main battery cable

and alternator connections.

·Install a filter capacitor (470㎌, 35volts) on the back of the cigarette

lighter socket, across the power connection.

If the receiving signal is weak:

·Check the angle of the detector. (Place it on the point of horizon.)

·Radar antenna/laser sensor is obstructed.

(Relocate the detector clear of any obstruction outside the

windshield, such as a wiper blade.)

·Relocate the detector clear of the window tint.

7.Specification

RADAR

Receiver Type : Dual conversion Superheterodyne

Antenna Type : Linear polarized, Self-Contained Antenna

Detector Type : Scanning Frequency Discriminator

Frequency of Operation : 10.525GHz/± 50MHz(X-Band)

24.150GHz/±100MHz(K-Band)

34.700GHz/±1,300MHz

(Ka Super Wideband)

LASER

Receiver Type : Pulsed Laser Signal Receiver

Detector Type : Digital Signal Processor Pulse

Width Discriminator

Opto Sensor: Dual Convex Condenser Lens and High Speed

Photo Diode Detector

Spectral Response : 800 ~ 1,100nm

GENERAL

Temperature Range : -4 to 158℉ (-20 to 70℃)

Power Requirements : 12 ~ 15V DC, 80㎃ nominal

(Negative Ground)

Dimensions(HWD) 1.1” x 2.5” x 3.6”

Weight : 2.2oz

Specifications are typical : individual units might vary.

Specifications are subject to change without notice.

Warranty

WARRANTY

This unit guaranteed against defects in workmanship and

materials for one year. Should you experience any difficulty

with the RMR-D210 during this time, the unit will be repaired or

replaced at no charge. Should you desire to have your unit

checked, there will be no additional charge other than postage

and handling. After the warranty period expires, the unit may

be returned for service and it will be reconditioned for ＄25.00

15 16 17 18

4. Operation

3) City / Highway Mode

·Press the Button.

→“City” LED turns on for “City” Mode.

4) Mute Mode

·Press Mute Button.

→Silences the Audio.

Note : Press button again to restore audio alarm.

5) VG-2 Select

·Hold down the Mute button for three seconds.

The RMR-D210 will disengage VG2 feature with beep sound.

Press Mute button again for three seconds.

The RMR-D210 will engage VG2 feature with three beeps.

The factory default is “VG2 On”.

6) Indicator and Visual

a. Power On

󳀏“P” LED turns on.

b. X Band Detection

󳀏“X” LED turns on with audible tone.

c. K/Ka Band Detection

󳀏“K/Ka” LED turns on with audible tone.

d. Laser Alarm

󳀏“L/V” LED and “X, K/Ka” LEDs flash with audible tone.

If the unit detects the laser signal when the City mode is

engaged, ALL LEDs will flash with audible tone.

e. VG2 Alarm

󳀏“L/V” LED flashes with audible tone.

7) Feature Memory

The RMR-D210 will automatically “Remember” your

settings when the unit is turned off or removed from the

power. All features selected are retained in memory-

Dim/Dark, City/Highway, VG2 and mute.

8) Feature Engage Confirmation

Each time a button is pressed two beeps confirm feature

“On”, one beep confirms feature “Off”.

109 11 12 13

ACCESSORIES

Accessories are available as follows:

Windshield mount ＄5.00

Power Cord ＄5.00

Suction cups(set of two) ＄2.00

2amp fuses(two ea.) ＄2.00

Replacement owner’s manual ＄3.50

Add ＄10.00 shipping and handling per shipment

CAUTION

Tampering with unit

will result in a ＄75.00 repair fee!

WE DO NOT ACCEPT COD SHIPMENT

ROCKY MOUNTAIN RADAR

6469 DONIPHAN DRIVE

EL PASO, TX 79932

915.587.0307

915.587.6408(FAX)

FCC Information

This product has been designed and certified to comply

with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any

interference received, including interference that may

cause undesired operation.

Any changes or modifications not expressly approved by

Rocky Mountain Radar may void your authority to use this

product.

1 2

Komentáře k této Příručce

Žádné komentáře

Rocky-mountain-radar RMR-D210 Uživatelský manuál Strana 2

Komentáře k této Příručce

Související produkty a manuály pro Pro auto Rocky-mountain-radar RMR-D210